KEPCO HSF 600W Series (suffix A and AM) Operator Manuals User Manual
Kepco, Operator’s manual, Hsf a, am 600 watts
Table of contents
Document Outline
- 1. Introduction
- 2. Specifications
- 3. Features
- 3.1 DIP Switch Configuration
- TABLE 4. DIP Switch 1 and 2 Functions
- FIGURE 4. DIP Switch Configuration
- 3.2 Front Panel Access.
- 3.3 Keying
- 3.4 Output Voltage Control
- 3.4.1 Front Panel Voltage Control
- FIGURE 5. Front Panel Controls, Indicators and Test Points (HSF AM, Typical)
- 3.4.2 Remote Voltage Control
- FIGURE 6. DIP Switch Settings for Control of Output Voltage
- TABLE 5. Minimum Conditions for Relay, Meter and LED Operation
- FIGURE 7. Connections For Remote Voltage Control
- 3.5 Remote On-Off
- FIGURE 8. DIP Switch Settings for Using RESET button or Remote ON-OFF
- 3.6 Protection Circuits
- 3.6.1 Overvoltage And Overtemperature Protection
- 3.6.2 Overcurrent Setting and Protection
- 3.6.3 Fan Failure
- 3.6.4 Undervoltage
- 3.7 Alarm Settings
- 3.7.1 Visual Alarm.
- FIGURE 9. DIP Switch Settings for Red Alarm Indicator Enable/Disable
- 3.7.2 Alarm Signals.
- 3.7.2.1 Internal Isolated Relay Alarm
- 3.7.2.2 Optically-Coupled Logical Alarm
- FIGURE 10. DIP switch settings for Optically Coupled Logical Alarm
- FIGURE 11. Output Alarm Circuit Optically Isolated
- FIGURE 12. ±PF Power Failure Optocoupler Timing Diagram
- 3.8 Local/remote Sensing
- 3.9 Retaining Latches
- 4. Load Connection
- 5. Connecting Multiple Power Supplies