KEPCO HSF 600W Series (suffix M and MZ) Operator Manuals User Manual
Kepco, Operator’s manual, Hsf (m, mz) 600w
Table of contents
Document Outline
- 1.1 Scope of Manual
- 1.2 Description
- FIGURE 1. HSF Rear Panel Connector and RA 19-4C Rack Adapter I/O Connector
- TABLE 1. HSF Rear Connector Pin Assignments
- TABLE 2. Output Ratings and Specifications
- FIGURE 2. Power Rating Vs. Temperature (Input: 95 to 264V a-c)
- TABLE 3. Power Supply Ratings and Specifications
- FIGURE 3. Mechanical Outline Drawing, HSF 600W M and MZ Models
- 3.1 DIP Switch Configuration
- FIGURE 4. DIP Switch Configuration
- 3.2 Front Panel Access.
- FIGURE 5. Front Panel Controls, Indicators and Test Points
- 3.3 Keying
- 3.4 Output Voltage Control
- 3.4.1 Front Panel Voltage Control
- 3.4.2 Remote Voltage Control
- FIGURE 6. DIP Switch Settings for Control of Output Voltage
- FIGURE 7. Connections For Remote Voltage Control
- TABLE 4. M Models: Minimum Conditions for Relay, Meter and LED Operation
- 3.4.3 MZ Models ONLY: VDC ON/Alarm Indicator Function
- FIGURE 8. DIP switch settings for VDC ON/ALARM Power Options
- TABLE 5. MZ Models: Conditions for VDC ON/ALARM LED Operation Powered by Output
- 3.5 Remote On-Off
- FIGURE 9. DIP Switch Settings for Using RESET button or Remote ON-OFF
- 3.6 Reset (Restart)
- 3.7 Protection Circuits
- 3.7.1 Overvoltage And Overtemperature Protection
- 3.7.2 Overcurrent Setting and Protection
- 3.7.3 Fan Failure
- 3.7.4 Undervoltage
- 3.8 Alarm Settings
- 3.8.1 Visual Alarm.
- 3.8.2 Alarm Signals.
- 3.8.2.1 Internal Isolated Relay Alarm
- 3.8.2.2 Optically-Coupled Logical Alarm
- FIGURE 10. DIP switch settings for Optically Coupled Logical Alarm
- FIGURE 11. Output Alarm Circuit Optically Isolated
- FIGURE 12. ±PF Power Failure Optocoupler Timing Diagram
- 3.9 Local/remote Sensing
- 3.10 Retaining Latches
- 5.1 Adjusting the Voltage
- 5.2 Parallel Connections, M Models
- 5.3 Parallel Connections, MZ Models
- 5.3.1 Minimum Load
- 5.3.2 Voltage Set Restrictions