Alliance Laundry Systems F232201R4 - Manual (Page 21)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
19 F232201
Pre-Operating Instructions
1. Press and release emergency stop button to direct
power to control module. Models with the
rotation sensor will display WE-6 Firmware ID
code HRWC18 and later or ARWCO1 and later.
Machine must perform a speed test. For models
without rotation sensor, proceed to step 1 of
Operating Instructions.
2. Display shows size of machine and will flash
“TEST?” and “SPEED” for 15 seconds.
3. Push Start keypad during the 15 seconds.
Machine will test rotation sensing for 15 seconds.
4. Display will flash “POWER” and “WAIT” one
time and will display “NEXT00.”
NOTE: If START is not pushed while display
flashes “TEST?” and “SPEED” or if rotation
sensing fails, then display flashes “POWER” and
“WAIT” before showing “NEXT00” for
approximately 2 minutes.
Operating Instructions
1. When display shows “NEXT00,” washer-
extractor is ready to be loaded with laundry.
2. On UW35 – UW125 models, use left hand to
press and hold the door unlock button located on
the lower right front of the control panel. Refer to
Figure 7.
Figure 7
3. On UW35 – UW125 models, use right hand to
turn door handle clockwise and swing the door
left to open. Refer to Figure 8.
Figure 8
MD003J
UW35 – UW125 MODELS
MD004J
Do not operate machine in a cycle with
program keymode switch in program
position. Program keymode switch must
be in run position at all times, except
when editing or programming cycle or
setup information.
W528
WARNING
Do not operate machine in a cycle or if
spinning with program keymode switch in
program position.
W529
WARNING
UW35 – UW125 MODELS