KANOMAX 6710 TABmaster Capture Hood User Manual - Manual (Page 22)

15
5.1.2 Test Mode settings
This setting is for change the test mode & the settings about the test modes. Refer to the
steps below:
¾ Under “Test Settings”, press or to select 2 “Test
Mode”.
¾ Press to enter into the “Test Mode” setting.
¾ Press to return to “MENU”.
¾ Press or to change the selected item as shown
below.
¾ Press to save or press to go back without saving.
¾ When “Run Avg” is selected, “Save Time” and “Auto Save”
must be set.
¾ Press or change the “Avg Time” value.
¾ Press to save or press to quit.
¾ Press or to change the selected item as shown
below.
¾ Press to save or press to go back without saving.
Single RunAvg B. Press
Off 10sec 20 sec 30sec 60 sec
Under option “B.Press”, press .
Under option “Single”, press .
MOVE
OK
BACK
Test Settings
1. Test ID
2. Test Mode
3. Unit
4. Act.Std SET
Std
2 Single
MOVE
OK
BACK
Test Settings
1. Test ID
2. Test Mode
3. Unit
4. Act.Std SET
Single
B.Press
RunAvg
MOVE
OK
BACK
Test Settings
1. Test ID
2. Test Mode
3. Unit
4. Act.Std
SET
Std
2 Single
MOVE
OK
BACK
Test Settings
1. Test ID
2. Test Mode
3. Unit
4. Act.Std
SET
Std
2 B.Press
MOVE
OK
BACK
Test Settings
1. Test ID
2. Test Mode
AvgTime：
Auto Save：
SET
Off
RunAvg
01 Sec
10 sec
20 sec
30 sec
60 sec
MOVE
OK
BACK
Test Settings
1. Test ID
2. Test Mode
AvgTime：
Auto Save：
SET
01
RunAvg
Off
Sec
Under option “Run Avg”, press .