KANOMAX 3522 Piezobalace Dust Monitor - Manual (Page 3)

Caution
* Do not drop or strike the instrument.
…… Dropping or hitting the instrument may
cause damage or a malfunction.
*
Never disassemble, modify or repair the instrument .
…… Failure to observe the above may cause a short circuit
or a malfunction.
* Do not block the impactor inlet.
…… Failure to observe the above may cause a pump failure.
* Do not perform a measurement in an environment with extreme
temperature or humidity changes.
…… Using the instrument in an environment with extreme temperature or
humidity changes may cause an error in the measurement value.
The allowable rate of change during a 2 minute measurement is:
Temperature: ± 1
°C (0°C to 40°C), Humidity: ± 1%RH (30%RH to 80%RH).
* Do not wipe the instrument with a volatile solvent.
…… The body may deform or deteriorate. Use soft dry cloth to remove stains.
If stains persist, dampen the cloth in a neutral detergent and wipe
the instrument.
Do not use volatile solvents such as thinner or benzine.
* Make sure there is no turbulent air flow near the sampling inlet.
…… Turbulent air flow may cause a measurement error.
* Do not clean the instrument in an environment where the
temperature is below 0 °C.
…… The cleaning sponge may freeze and cause damage to the sensor.
Prohibition
Do not modify / disassemble
Handle Properly
Prohibition
Handle Properly
Prohibition
Prohibition