KANOMAX 3522 Piezobalace Dust Monitor - Manual (Page 16)

11
Press MEAS/CLN
The high voltage pointer moves
to the center, and the operating
status changes to “READY”.
Operating status
5. Measurement Method
5.1 High Voltage Supply
When the instrument is turned on, the flashing “WAIT” message will be displayed. After a brief
delay, the “WAIT” message will stop flashing, and high voltage can be supplied. Press
[MEAS/CLN] to supply high voltage. The pointer at the left end of the high-voltage indicator
frame will move toward the right. The pointer will stop at the center of the frame under the black
block. When the sensor becomes stable, the operating status will change from “WAIT” to
“READY” and the instrument will be ready for measurement.