KANOMAX 3522 Piezobalace Dust Monitor - Manual (Page 20)

15
6.3 Data Output Menu
To select and view stored data
Move the cursor to item “3. DATA OUTPUT” on the main menu by using △ and ▽ then
press [SET]. The screen shown below will be displayed.
If there are no stored data records, the message “There is no record. Please set MENU key” will be
displayed.
Select a data storage number by using △ and ▽ .
When you release the key, the contents of the data record
(concentration, date/time, sampling time and sampling
status) will be displayed.
No:
Data storage number
MASS CONCENTRATION: Measured concentration value
DATE / TIME:
Date and time the measurement was performed
SAMPLING TIME: Sampling mode: 24s, 120s or TSET (1-60min).
STATUS: Sampling status: 0 or 1
0: Normal measurement condition
1: Indicates the measurable range was exceeded during the
measurement in sampling mode 24s or 120s.
6.4 Time Adjustment Menu
To set the data and time
Move the cursor to item “6. TIME ADJUST” on the
main menu by using △ and ▽ then press [SET].
The screen on the left will be displayed.
Press [SET] when “1” is highlighted to change the date
or when “2” is highlighted to change the time. The cursor
will move to the date or time field as shown to the left.
Set the year, month and day (or hours, minutes and
seconds) by using △ and ▽ . Press [SET] to
proceed to the next field. When all the fields are set, the
cursor will return to the left side of the screen.
Once the date and time are set use △ and ▽ to
select “3.SAVE INFO” and press [SET].
Note: The time setting is confirmed when you press [SET]
here. If you require the instrument to be set to an exact time
Select “1.DATE”
and press
Select “2.TIME”
and press
SET
SET