KANOMAX 3522 Piezobalace Dust Monitor - Manual (Page 19)

14
6. Settings Menu
6.1 Main Menu
The following menu will be displayed by pressing [MENU] (when high voltage is not being
supplied to the instrument). Use △ and ▽ to select an item.
To enter the sub-menu of each item, press [SET].
To return to the measurement screen, select “1. NORMAL” and press [SET].
6.2 Sampling Time Menu
To set the measurement sampling time
Move the cursor to item “2. SAMPLING TIME” of the
main menu by using △ and ▽ then press [SET].
The screen on the left will be displayed.
Caution: If [MENU] is pressed before confirming
changes by pressing [SET] at “2. SAVE INFO”, changes
made to the time will NOT be saved.
Change the sampling time by using △ and ▽ .
The setting will change as shown below:
120s 24s TSET
Press [SET] when 120s or 24s is highlighted if you wish
to use one of the preset sampling times, then confirm the
changes by pressing [SET] at “2. SAVE INFO”.
When [SET] is pressed when “TSET” is highlighted, the
following screen will be displayed.
Set the time by using △ and ▽ . The sampling
time range can be set from 1 to 60 minutes. Press [SET]
when the sampling time has been set, then confirm the
changes by pressing [SET] at “2.SAVE INFO”.
Note:
After completing the time setup, you can confirm your changes on the measurement screen. If you
have set a custom time using TSET, the display will simply show “TSET” (the specified time will
not be displayed.) The set time will be the range of the elapsed time indicator.
Select “1” and
press .
SET
01m
Select “TSET”
and press
SET