In-Situ O-ring Replacement Kit for the optical RDO PRO Probe User Manual
Instruction sheet, O-ring replacement kit for the rdo, Pro and rdo
Instruction Sheet
O-Ring Replacement Kit for the RDO
®
PRO and RDO
®
PRO-X Probe
Part Number 0080810
Kit Contents
1
Lens cloth
2
Lubricant
3
O-ring for probe body
4
Internal nose cone O-ring
5
Sensor cap O-rings
Replacement Procedure
1. Remove the nose cone from the probe.
2. Use your fingers or a non-metallic tool to remove the
worn O-rings from the grooves.
3. Clean all contact surfaces with a swab or lint-free
cloth.
4. Using your fingers, apply lubricant evenly to the new
O-rings.
5. Place the mid-sized internal nose cone O-ring in the
nose cone.
1
Mid-sized internal nose cone O-ring
6. Place the probe body O-ring on the probe housing.
7. Place the sensor cap O-rings in the grooves on the
sensor.
8. Do not transfer lubricant from your fingers to the gold
pins on the sensor or the inner lens of the sensor.
1
Probe body O-ring
2
Sensor cap O-rings
9. Clean the lens with the enclosed lens cloth after
placing the two O-rings on the sensor.
10. Place the nose cone on the probe.
Information subject to change without notice. In-Situ, In-Situ logo, Baro Merge, BaroTROLL, HERMIT, iSitu, Pocket-Situ, RDO,
RuggedCable, RuggedReader, TROLL, and Win-Situ are trademarks or registered trademarks of In-Situ Inc.
©
2013. All rights reserved.
11/2013 | Rev. 002 | 0080812