In-Situ Rugged Level Tape 100 and Rugged Level Tape 200 - Manual (Page 2)

Information subject to change without notice. In-Situ, In-Situ logo, Baro Merge, BaroTROLL, HERMIT, Pocket-Situ, RDO, RuggedCable, RuggedReader, TROLL, and Win-Situ are trademarks or registered
trademarks of In-Situ Inc. © 2011. All rights reserved.
For more information, contact In-Situ Inc.
221 East Lincoln Avenue, Fort Collins, CO 80524
1-800-446-7488 (toll-free in U.S.A. & Canada)
1-970-498-1500 (international & domestic)
www.in-situ.com
0070002 rev. 004w 6/11
1. Battery box 2. Signal LED
3. Signal buzzer
4. Sensitivity knob for cascading
water. Not an On/Off switch.
5. Test button 6. & 7. Panel attachment knobs
Cleaning
Always clean the Rugged Level Tape after use to 1.
maintain optimal performance and extend the life
of the unit. Properly clean the unit to prevent cross-
contamination between wells.
Unwind the tape and wash the tape and probe with a
2.
mild detergent. Rinse well, wipe with a soft cloth, and
rewind onto the reel.
Remove the electronics module before washing the reel.
3.
Remove the two knobs that secure the control panel to
the reel. Carefully pull the module out of the reel. Wash
the reel with a mild detergent and dry completely before
reinstalling the module.
Important: Do not use abrasive materials, partially halogenated
hydrocarbons or ketones to clean the reel.
Figure 3. Control panel
General Guidelines
Do not scrape the tape against sharp-edged well casing. •
Avoid entanglement with other equipment in boreholes •
and wells.
Do not use this unit as a guide for backfilling with sand
•
because the probe may become trapped.
Rewind the tape onto the reel after each use.
•
Figure 4. Rugged Level Tape 200 installed in well
ASME certification does not apply to the Rugged Level Tape 100 or the Rugged Slim Tape.