In-Situ smarTROLL Multiparameter Handheld Battery Pack - Manual

Instruction Sheet
SMAR
TROLL™ Battery Pack
Part Number 0099118
Battery Pack Description
The battery pack enables wireless communication
between the iOS device and the probe and supplies
power to the probe. The battery pack provides a
barometric pressure measurement that is used to
compensate depth and dissolved oxygen
measurements. The ambient temperature
measurement is also provided by the battery pack.
Kit Contents
l
Battery pack
l
4 AA lithium batteries
Install the Batteries
The 4 AA batteries that are shipped with the battery
pack are likely to last for 80 hours of continuous use.
1 Power indicator
2 On/Off button
3 Belt clip
4 Battery compartment latch
5 Cable connection
1. Twist the cable connector counterclockwise to
remove the cable from the battery pack.
2. Slide the lever on the battery compartment to release
the cover.
3. Install the 4 AA batteries according to the +/-
indicators engraved on the outside cover.
4. Close the cover and slide the lever to lock the
compartment.
Information subject to change without notice. In-Situ, In-Situ logo, BaroMerge, BaroTROLL, HERMIT, iSitu, Pocket-Situ, RDO,
RuggedCable, RuggedReader, TROLL, and Win-Situ are trademarks or registered trademarks of In-Situ Inc.
© 2013. All rights reserved.
04/2013 | Rev. 001 | 0099112