In-Situ Large Desiccant for Use with RuggedCable Systems User Manual
Large desiccant
Information Sheet
Due to continuing product development this information is subject to change without notice. In-Situ and the In-Situ logo, Win-Situ, TROLL, BaroTROLL,
RuggedReader, RuggedCable, and RDO are trademarks or registered trademarks of In-Situ Inc. Copyright © 2005-2008 by In-Situ Inc. All rights reserved.
1 800 446 7488
(toll-free, US and Canada) or 970 498 1500
www.in-situ.com
Level TROLL
®
Accessories
Aqua TROLL
®
Accessories
MP
TROLL
®
9500 Accessories
Catalog No. 0051810 and 0053550
Large Desiccant
Description
A clear acrylic tube with replaceable indicating desiccant, designed to protect a
vented Twist-Lock cable in high-humidity environments. Desiccates 20 times more
saturated air than the standard small desiccant. The desiccant gradually turns from
blue to pink as it absorbs moisture.
Material
Clear acrylic body, titanium or ABS connectors
(0051810 and 0053550, respectively), HDPE
membrane (high density polyethylene)
Environmental Rating
Weatherproof, not designed for submersion
Size
3.2 cm (1.25 in) O.D., 11.4 cm (4.5 in) long
Desiccant
approx. 22 g silica gel, type 4
Est. desiccant life (at 90% R.H.)
≥ 2 months to 50% saturation, depending on site
conditions
connections
1. Remove the protective dust cap from the bottom of the desiccant pack, if applicable.
2. Remove the small desiccant (if present) from the RuggedCable by grasping the
knurled (textured) section of the cable connector in one hand and the desiccant in the
other. Twist in opposite directions to unlock the desiccant from the cable.
3. Attach the large desiccant to the Twist-Lock connector on the cable.
Attaching cables and accessories is a simple matter of mating the Twist-Lock
connectors. This is easy after you've done it once or twice. For detailed steps and
photographs, see the product Quick Start Guide, or the Operator's Manual.
4. Remove the red dust cap to allow air to reach the cable's vent tube, if applicable.
guiDeLines & precautions
• To communicate with the instrument, remove the desiccant and attach a TROLL Com
to the cable.
• Desiccant will absorb moisture from the top down and for best results should be re-
placed before the entire volume has turned pink. A refill kit, Cat. No. 0029140, is avail-
able from In-Situ Inc. or your distributor.
• Protect new desiccant from moisture until ready to use.
Be sure to remove the red dust cap
from the top of the #0051810 desic-
cant before instrument deployment.
0051812 rev. 005 07/08
Mating pin
Dust cap
O-ring
Vented cap with
hydrophobic membrane
Dust cap—remove before use
0051810
0053550