In-Situ Rugged TROLL Com Device for Rugged TROLL 200 and Rugged BaroTROLL - Manual (Page 2)

For more information, contact In-Situ Inc.
221 East Lincoln Avenue, Fort Collins, CO 80524
1-800-446-7488 (toll-free in U.S. & Canada)
1-970-498-1500 (international & domestic)
www.in-situ.com
In-Situ and the In-Situ Inc. logo, Baro Merge, BaroTROLL, HERMIT, RDO, RuggedCable, RuggedReader, TROLL, and Win-Situ are trademarks or registered trademarks of In-Situ Inc.,
Fort Collins, CO, USA. Copyright © 2010 by In-Situ Inc. All rights reserved.
COnneCTIOnS
Connect to
uphole end of
cable
Release tab
USB connector
Battery door
Attach the Rugged TROLL Com to the Rugged TROLL 200 cable via snap-on 1.
connection to the uphole end of the cable.
Connect the RS232 serial connector or USB connector to the PC or RuggedReader
2.
handheld PC (RS232 serial connector only).
The Rugged TROLL 200 and Rugged BaroTROLL instruments require a minimum of 8 VDC. If you
lose connection to your instrument, particularly over long cable lengths, replace the 9 V battery.
Release the connection to the uphole cable end by pushing the white tab.
RS232 serial connector
0092002 rev. 002 06/10