In-Situ Dissolved Oxygen: RDO Sensor Calibration Kit for Cabled Sensors (purchased before 09/2008) - Manual

Information Sheet
Due to continuing product development this information is subject to change without notice. Copyright © 2004-2005 by In-Situ Inc. All rights reserved.
1 800 4INSITU
(toll-free, US and Canada) or 970 498 1500
www.in-situ.com
Multi-Parameter
Water Quality TROLL ®
RDO SENSOR
MAINTENANCE KIT
Catalog No. 48250
The RDO Optical Dissolved Oxygen Sensor maintenance kit includes a
replacement Phillips head screw for the adapter plate, and o-rings in the
following sizes:
3.028” I.D., p/n 0048260 (2), non-sealing o-rings for the adapter plate and nose
cone
0.489" I.D., p/n 0048270 (2), locking, non-sealing o-rings for the RDO sensor
0.301” I.D., p/n 0041230 (2), locking, sealing o-rings for the cable harness, with
lubricant
Replace the o-rings if they appear cracked or damaged.
GUIDELINES & PRECAUTIONS
• A and B are non-sealing o-rings; they do not need lubrication
• C are sealing o-rings; apply silicone grease to o-ring and grooves before
installation. Take care not to transfer grease to the pins of the connector,
which would be then transferred into the sensor port. Remove lubricant in
these areas with a clean swab.
Non-sealing o-rings
A
A
Locking, non-sealing o-rings
B
Locking, sealing o-rings
C
0048252 rev. 001 10/05
A
B
C