In-Situ Suspension Wire for Use with Backshell Hanger - Manual

(toll-free, US and Canada) or 970 498 1500
www.in-situ.com
Due to continuing product development this information is subject to change without notice. In-Situ and the In-Situ logo, Win-Situ, TROLL, BaroTROLL,
RuggedReader, and RuggedCable are trademarks or registered trademarks of In-Situ Inc. Copyright © 2007, 2008 by In-Situ Inc. All rights reserved.
1 800 446 7488
Information Sheet
TROLL ® Accessories
Ordering infOrmatiOn CatalOg nO.
q 50 ft ...................................................................................................... 0066470
q 150 ft ..................................................................................................... 0066460
q 300 ft ..................................................................................................... 0066450
desCriptiOn
Poly-coated 304 stainless steel wire rope for hanging a pre-programmed probe
while taking data. No communication capabilities, no venting. Nylon caps on cut
ends of cable deter water incursion. Installation clips included.
Cable ratings
Temperature
-65°C to 105°C (-85°F to 221°F)
Weight 0.28 kg /30 m (0.60 lb/100 ft)
Overall O.D. 2.2 mm (0.087 in) ± 0.003 in
bare Cable
Material
304 stainless steel, 7 x 7 strand
O.D. 1.3 mm (0.051 in) ± 0.003 in
Breaking strength 270 lb*
* With proper tightening of clips
COating
Material
Polyester elastomer insulation
Color Black
Wall thickness min. 15 mils
guidelines & preCautiOns
• Attach and suspend the instrument using good rigging
techniques. We recommend two clips at each end of the cable.
• Allow about 2 inches of cable between the probe hanger and
the first cable clip.
• Clips are 300 series SS, 1/16". Install with the u-bolt over the
"dead" or short end of wire, and the "live" or long end resting in
the saddle of the clip. Tighten with 7/32" nut driver.
• We recommend that you retighten the nuts once the cable
relaxes after hanging for about an hour.
0066452 rev. 003 09/08
COated stainless steel
suspensiOn Cable
Catalog No. 0066450, 0066460, 0066470
2"
2"
u-bolt
Clip
saddle