beautypg.com

In-Situ RuggedCable Systems—Use and Care of RuggedCable Systems User Manual

Using the ruggedcable, System

background image

Information Sheet

TROLL

®

Accessories

Using the RuggedCable

®

System

TwiST -LoCk CabLe ConneCTionS
1. Remove the protective caps from the instrument connector end and cable

connector end.

Instrument connector end

Cable connector end

TIP: Retain the dust caps to protect the pins and o-ring from damage when cable is
not attached.

2. Take a moment to look at the connectors. Each has a flat side.

Flat

Flat

Instrument

Cable

Note the pins on the body connector (one on each side) and the slots on the
cable connector (one on each side).

pin

slot

3. Slide back the sleeve on the cable connector.

4. Orient the “flats” so they will mate up, and insert the instrument connector

firmly

into the cable connector.

Instrument

Cable

5. Slide the sleeve on the cable toward the instrument body until the pin on the

body pops into the round hole in the slot on the cable connector.

Instrument

Cable

ALWAYS REMEMBER!

Before using your cables, make

sure that the connector end of your
instrument has a greased o-ring that
is in good condition (not cracked or
sheared).
Before using your cables, make

sure that each cable end contains
a gasket. This ensures a secure
connection with the instrument.
Cables can be sheared off by heavy

machinery or the careless use of
cutting tools. Pay attention!