In-Situ Backshell / Twist-Lock Hanger for Use with Suspension Wire - Manual

Information Sheet
Due to continuing product development this information is subject to change without notice. In-Situ and the In-Situ logo, Win-Situ, TROLL, BaroTROLL,
RuggedReader, RuggedCable, and RDO are trademarks or registered trademarks of In-Situ Inc. Copyright © 2005-2006 by In-Situ Inc. All rights reserved.
1 800 446 7488
(toll-free, US and Canada) or 970 498 1500
www.in-situ.com
Level TROLL ® Accessories
Aqua TROLL ® Accessories
MP TROLL ® 9500 Accessories
Catalog No. 0051480 (titanium),
0055050 (steel)
TWIST-LOCK HANGER
Check to be sure there is a small black mechanical seal inside
the hanger before attaching it.
Attaching cables or accessories is a simple matter of mating the Twist-
Lock connectors. This is easy after you've done it once or twice. For
detailed steps and photographs, see the product Quick Start Guide, or
refer to the Operator's Manual located on the software CD.
APPLICATION
Seals and suspends a pre-programmed instrument in a well or other site while
taking data. No communication capabilities, no venting. Allows use of inexpensive
suspension wire.
PHYSICAL DESCRIPTION
Material
Titanium or 316L stainless steel
Dimensions 44.2 mm (1.74 in) long, 18.3 mm (0.72 in) O.D.
Hanger opening 9 mm (0.38 in)
Weight Titanium, 21.7 g (0.75 oz)
Steel, 38 g (1.3 oz)
CONNECTIONS
The hanger can be attached to a hook or threaded with suspension wire.
The bayonet-type Twist-Lock connector end attaches directly to the instrument body.
ORDERING INFORMATION CATALOG NO.
Twist-Lock Hanger (titanium) for BaroTROLL, Level TROLL 500,
Level TROLL 700, Aqua TROLL 200, MP TROLL 9500 .......................... 0051480
Twist-Lock Hanger (steel) for Level TROLL 300 .......................................... 0055050
Coated suspension wire ............................................................................... 0026460
GUIDELINES & PRECAUTIONS
• The Twist-Lock Hanger is not vented. Do not use with vented (gauged) pressure
sensors.
• For accurate measurements, the instrument should remain immobile while
taking data.
• To communicate with the instrument, remove the Twist-Lock Hanger and attach
RuggedCable
™ and a TROLL Com (or a Programming Cable).
B
A
Twist-Lock
connector
Hanger
Twist-Lock Hanger
Non-vented
Level TROLL,
Aqua TROLL,
or MP TROLL 9500
Suspension wire
A
B
0051482 rev. 003 10/06