In-Situ Artesian Well Cable Option (factory installed) for Level TROLL and miniTROLL - Manual

Information Sheet
Due to continuing product development this information is subject to change without notice. In-Situ and the In-Situ logo, Win-Situ, TROLL, miniTROLL, BaroTROLL,
RuggedReader, RuggedCable, and RDO are trademarks or registered trademarks of In-Situ Inc. Copyright © 2000 – 2007 by In-Situ Inc. All rights reserved.
1 800 446 7488
(toll-free, US and Canada) or 970 498 1500
www.in-situ.com
Level TROLL ® Accessories
ARTESIAN WELL CABLE
OPTION
(SEALED WELL APPLICATIONS)
APPLICATION
Permits installation of a Level TROLL ® or miniTROLL ® into a sealed well where the
seal is made around the cable. Allows easy removal from a ¾" NPT application.
Includes a black dome compression fitting that makes a water- and air-tight seal
around the cable.
Components are factory-installed on the Level TROLL RuggedCable™ or
miniTROLL Quick-Connect cable
COMPONENTS
Black two-piece dome connector with ½" male threads (NPTM)
White PVC adapter that accepts connector A (interior threads are ½" female, NPTF)
and mates with ¾" NPT threads
INSTALLATION
1. Loosen halves of connector A and slide to desired position on cable.
2. Tighten the compression fitting firmly around the cable and screw into PVC
adapter B for installation into ¾” NPT fitting.
Additional adapter(s) may be added for installation into 1” or other size NPT fitting.
A
B
}
½" NPTM
¾" NPTM
0027772 rev. 002 07/07
A
B
TIP: Cable may be ordered with the sealing fittings below the
service grip (Method 1) or above the service grip (Method 2),
depending on well configuration.
Service
grip
Fittings
Service
grip
Fittings
Method 1 Method 2