beautypg.com

8 warranty conditions, Warranty information, Warranty void conditions – In-Situ Level TROLL Data Loggers Care & Maintenance Guide User Manual

Page 6: Instruction sheet, Warranty conditions

background image

Instruction Sheet

decontaminated) and send it with each returned
instrument.

l

We recommend a cleaning solution, such as
Alconox

®

, which is a glassware cleaning product

available from In-Situ Inc. (part number 0029810)
or laboratory supply houses.

l

Clean all cabling. Remove all foreign matter.

l

Clean cable connector(s) with a clean, dry cloth.
Do not submerge cable connectors.

l

Clean the probe body—including the nose cone,
cable head, and protective caps. Remove all
foreign matter.

If an instrument is returned to our Service Center for
calibration or repair without a statement that it has been
cleaned and decontaminated, or in the opinion of our
Service Representatives presents a potential health or
biological hazard, we reserve the right to withhold
service until proper certification has been obtained.

Warranty Conditions

Warranty Information

Visit www.in-situ.com/warranty for the most current
product warranty information.

Warranty Void Conditions

Your In-Situ Inc. instrument has been designed to
withstand harsh field conditions. However, as with any
electronic instrument, it can be permanently damaged if
subject to the following conditions.

l

Used outside of operating specifications

l

Handled or cleaned improperly

l

Maintained incorrectly, including improper use and
replacement of desiccant

Neglecting any instructions or warnings in your
Operator's Manual or related In-Situ Inc. documentation
may cause damage to your instrument, your warranty to
become void, or both. Please follow all instructions and
warnings to avoid damage to your product.

The presence of the Waste Electrical and Electronic
Equipment (WEEE) marking on the product indicates that the
device is not to be disposed via the municipal waste collection
system of any member state of the European Union.

For products under the requirement of WEEE directive, please
contact your distributor or local In-Situ Inc. office for the proper
decontamination information and take back program, which will
facilitate the proper collection, treatment, recovery, recycling,
and safe disposal of the device

800-446-7488

6

www.in-situ.com

This manual is related to the following products: