In-Situ TROLL Shield Nose Cone for Level TROLL 500/700 and Aqua TROLL 200 Instruments - Manual

(toll-free, US and Canada) or 970 498 1500
www.in-situ.com
Information is subject to change without notice. In-Situ and the In-Situ logo, Win-Situ, TROLL, BaroTROLL, RuggedReader, and RuggedCable are trademarks or
registered trademarks of In-Situ Inc. Copyright © 2008 by In-Situ Inc. All rights reserved.
1 800 446 7488
Information Sheet
TROLL ® Accessories
0081482 12/08
TROLL ® Shield Nose Cone
Catalog Number 0081480
OveRview
The TROLL Shield copper nose cone is designed to reduce macro- and micro-
fouling of the pressure sensor on Level TROLL
® and Aqua TROLL ® instruments.
Reduced fouling on the sensor improves measurement accuracy and extends the
length of instrument deployments.
Use with:
Level TROLL 300, 500, and 700 instruments •
Aqua TROLL 200 instruments •
For optimum performance, replace the nose cone every 12 months.
iNSTRuCTiONS
Remove the existing nose cone. 1.
If the ports in the front end are clogged with silt or mud, try the following: 2.
Gently • dip the sensor end into a cup of clean water and swirl slowly.
From the outside of the sensor body, • carefully clean plugged holes with a
soft brush.
To remove hard deposits, soak the sensor end overnight in a mild acidic
•
solution, such as household vinegar. Gently rinse with water afterwards. Do
not fully submerge the instrument.
Securely attach the TROLL Shield copper nose cone. 3.
OTheR ACCeSSORieS
TROLL ® Shield antifouling guard
for the Aqua TROLL ® 100 and 200 instruments.............................................0085190
When the nose cone is removed, the sensitive
pressure sensor diaphragm is completely
exposed. Do not touch this area with any
object!
To avoid damage to the pressure sensor
diaphragm, do not insert any object into the
sensor opening or attempt to dig out dirt or
other materials. Damage caused by digging or
scraping in the pressure sensor opening is not covered
by the warranty.