GW Instek GDS-122 Installation Guide - Manual (Page 2)

GDS-122 Rechargeable Battery Pack
authority, or official representative for assistance in
recycling of the battery pack.
Battery Replacement and Installation Procedure Battery Replacement and Installation Procedure Battery Replacement and Installation Procedure Battery Replacement and Installation Procedure
To avoid potential hazards, use this product only as specified.
Note Replacement of the battery is an easy procedure that can
be performed with basic equipment. Please note that the
serial number on the face of the old battery must be
transferred to the new battery to retain warranty and
service records. The serial number location is shown
below.
Serial number
location
Equipment
•
Phillips screw driver x 1
•
Hobby knife x 1
•
Super glue (or any plastic bonding epoxy)
1. Remove the protective
rubber casing.
2. Remove three retaining
screws on the rear.
Replacement
Procedure
3. Take out the hinge
assembly and rear stand.
4. Remove the four screws
under the rear stand.