Detcon 1600-N1P-RD - Manual (Page 9)

1600/6400-N1P-RD
The controller may be configured to have less than eight channels per ‘Zone’. Only those ‘Zones’ with active
channels will be displayed. When any channel in a ‘Zone’ has an alarm or fault condition, the ‘Zone’ key will
begin to flash, and the controller will automatically display the channels in that ‘Zone”. When there are alarms
or faults in multiple ‘Zones’, the controller will display each zone for 10 seconds and rotate to the next ‘Zone’.
The display will continue to rotate through each ‘Zone’ until a ‘Zone’ key is selected by the user.
The main function keys reside across the bottom of the Main Display area. They are: Program Menu, Alarm
Reset, Alarm Silence, and Cal Mode.
Program Menu takes the operator to the functions for configuration, set-up and data retrieval.
Alarm Reset Has no function in the Remote Display.
Alarm Silence Has no function in the Remote Display.
Cal Mode Has no function in the Remote Display.
5.3 Program Menu Selections
Figure 4 Program Menu
5.3.1 Select # Active Channels and Relays
The ‘Select Active Channels and Relays’ screen is used to set the active number of input channels for which
the 1600/6400 Controller is currently programmed. This number must be consistent with the number of
sensors and I/O modules connected to the system and must match the number entered in the 1600/6400
Controller.
1600/6400-N1P-RD- Instruction Manual Rev. 1.0 Page 5 of 14