Delmhorst Instrument Moisture Check - Manual (Page 14)

Copyright  2005, Delmhorst Instrument Co.
Page 14 of 29
•
When the meter is set to Triggered mode, a single reading is taken every time
the SELECT button is pressed. Each reading is stored in memory. The last
measurement remains displayed on the screen.
•
When the meter is set to Continuous mode, press SELECT key to initiate the
reading cycle. The meter keeps taking MC readings in this mode. These readings
are NOT stored until the SELECT key is pressed again. To exit continuous mode
WITHOUT STORING the current reading, press any directional key (
с т and
п р). To exit continuous mode and STORE the current reading, press the
SELECT key. Exiting continuous mode leaves the last reading on the screen. To
resume continuous mode, press the SELECT key again. Use the
с т and
п р keys to choose a different option.
4. At any time, you may modify Temperature (T).
The EXIT option in both SCAN and PIN MODE menus will cancel the measurement
process and will put the meter in the MAIN MENU.
TO TAKE SCAN READINGS IN ENHANCED MODE:
1. In the MAIN Menu, highlight option #2: SCAN
The screen will look as follows:
2. You may begin taking readings by firmly pressing the back of the meter onto the
material.
3. This will display a relative reading that ranges between 0 and 300.
TO SET THE ALARM IN ENHANCED SCAN MODE:
1. If you wish to set the alarm to beep after a pre-selected relative value is reached,
highlight option #2: SCAN MODE from the ENHANCED main menu. This will bring
you to the SCAN screen.
2. Use the ò and ð keys and highlight ALARM: OFF. Press the SELECT key to enter
the alarm sub menu.
3. The default status of the alarm is “OFF.” Press the SELECT key to turn it on.