DeFelsko PosiTector DPM v.3.1 Full Manual - Manual (Page 20)

17
The PosiTector DPM can automatically record datasets into
memory at user selected time intervals. When selected, the Auto
Log icon will appear on the display with a timer counting down
until the next dataset is stored. Readings on the display are only
updated when a dataset is stored. Connect the Gage to a USB
power source for long-term use using the included USB cable.
Auto Log Mode Auto Log Mode
Standard models remain powered-up while in auto log mode.
The Gage will store datasets for 40-50 hours on a set of fresh
alkaline batteries depending on the frequency of measurements.
Advanced models power down between measurements to
conserve batteries. At each interval, the Gage will wake up, take a
reading, sync to PosiSoft.net (if selected) and power down. The
Gage can record approximately 8,000 datasets while in this mode
using fresh alkaline batteries, or approximately one reading every
hour for eight months.
- Auto Log continues recording until memory is full, the Gage
loses power, or the user turns off Auto Log mode. Stored datasets
will remain in memory.
- To conserve battery life, readings update only at the Log Interval.
The last recorded readings will remain “frozen” on the display until
the next dataset has been stored.
- It is recommended that fresh alkaline batteries or newly
recharged batteries be installed prior to an extended Auto Log.
NOTES:
Turn on Gage/
Cancel Auto Log
mode Scroll through dis-
play modes
(Advanced only)