DeFelsko PosiTector DPM v.3.1 Full Manual - Manual (Page 10)

7
Optionally, the Magnetic Surface Temperature Probe can be
disconnected from the K-Type thermocouple connector (separate
probe models only) and replaced with one of the following
accessories:
Hand-held Surface Temperature Probe
- for spot checking hard-to-reach surfaces
Self-adhering Surface Temperature Probe
- sticks to solid materials including aluminum, wood, concrete,
etc. Ideal for unattended monitoring.
Liquid Temperature Probe
- general purpose probe with stainless steel shaft
The PosiTector DPM consists of a body and a probe. Two probe
models (Built-In and Separate) are offered, as pictured below. All
bodies accept all probes. See Gage Info (pg. 11) to find your body
and probe type. More information is available at:
www.defelsko.com/dewmeter.htm
To disconnect a probe from a body, power-down the
Gage and pull the plastic probe connector horizontally (in
the direction of the arrow) away from the body. Reverse
these steps to attach a new probe.
When powered-up the PosiTector automatically
determines what type of probe is attached and does a
self-check.
Probes Probes
Air temperature
and humidity
sensors
Separate probe
with magnetic
surface
temperature
sensor
Surface
temperature
sensor