Catskill Craftsmen 1521 - Manual (Page 12)

STEP 9
A. Fit a washer onto the bottom door pin and slide
the pin into the bottom front brace.
B. Slide the Top Front Brace into
place and secure the brace using
1 3/4” machine screws and nuts as
in illustration 9A & 9B.
C. Tap 1” pins into Side Panel as in illustration 9B.
These will hold the shelves.
IMPORTANT! - To guarantee proper positioning,
loosen the screws holding in the full extension
drawer glides, and shift the glides back against the
back panel. Retighten the screws.
2 Used
in this step
1 3/4” Phillips Flat Head Bolt
10-24 Hex Nut
2 Used
in this step
4 Used
in this step
1” Long 3/16” DIA. Steel Pin
ILLUSTRATION 9A
ILLUSTRATION 9B
2 Used
in this step
1 3/4” Phillips Flat Head Bolt
10-24 Hex Nut
2 Used
in this step
4 Used
in this step
1” Long 3/16” DIA. Steel Pin
2 Used
in this step
1 3/4” Phillips Flat Head Bolt
10-24 Hex Nut
2 Used
in this step
4 Used
in this step
1” Long 3/16” DIA. Steel Pin
STEP 10
Invert unit, or lay the unit on its back to insert the
wheels. Have a friend help with this step as the unit
can be heavy and awkward to move.
A. Insert and tap caster sockets with hammer until
the teeth grab the wood. DON’T POUND SOCKET
FLAT OR CASTER SHAFT WILL NOT ENTER.
B. Insert casters and seat by pushing straight
downward with heel of your hand, or tap into place
with a hammer. Don’t be afraid to give them a good
downward whack on the solid metal part of the
caster!
C. Locking wheels usually go on front.