Avigilon Stentofon AlphaCom Integration - Manual (Page 9)

Avigilon Control Center 5 System Integration Guide with STENTOFON AlphaCom
6
Avigilon Stentofon Gateway
The Avigilon Stentofon Gateway is composed of two parts: the Avigilon Stentofon
Gateway Windows service that runs automatically in the background, and the Avigilon
Stentofon Gateway configuration application that is used to configure the connection and
alarm mappings between the STENTOFON and the Avigilon systems.
Configuring Server Settings
Configure the Alarm Mapping Gateway to access the two applications.
The configuration application remembers the server configuration, so you do not need to
repeat this procedure if the settings remain the same.
After you install the integration software, the Configuration Tool automatically opens. To
access it manually, select All Programs > Avigilon > Avigilon Stentofon Gateway >
Configure Avigilon Stentofon Gateway.
• If you upgraded your integration and all the configurations were successfully
imported, you will automatically see the Configuration Tool window. Click
Configure Connections.
NOTE: If you have multiple server connections to the same Avigilon Site, remove all but
one of the connections. When you have servers organized in a Site, you only need
one server connection to access all the alarms within a Site. Keeping multiple
server connections will duplicate the alarms listed in the Configuration Tool.
• If this is a new installation, you will automatically see the Configure
Connections dialog box. Click Add.
a.
In the following dialog box, enter the Avigilon Server IP Address, User
Name and Password, then click OK.
Use the username and password you created for the integration. See Adding
an Integration User in Avigilon on page 4.
NOTE: If multiple servers in the Site are needed in the integration, you only need to add
one server from the Site to have access to all the alarms in the system. You only
need to add the Avigilon Control Center Server that hosts the integration license.