Backing up mapped alarms, Restoring mapped alarms, Backing up mapped alarms restoring mapped alarms – Avigilon AMAG Symmetry 7 Integration User Manual
Page 15
Avigilon Control Center 5 System Integration Guide with AMAG SMS
11
2.
In the Avigilon area, select the alarm you want to map to. Listed here are the
alarms you created in Setting Up Gateway Alarms in Avigilon on page 4.
3.
Click >>.
4.
Click Save.
5.
Repeat the previous steps until all the required alarms have been mapped.
6.
Once all the required alarms have been mapped, click Save and Apply. The
Gateway Windows service is updated with all the new or changed mappings.
Backing Up Mapped Alarms
After you finish mapping all the alarms in the Configuration Tool, you can choose to back
up a copy of the mappings.
If you are performing this procedure before upgrading the integration, be aware that in
older versions of the integration the backup file is located in the same folder but is labeled
GatewayParams.xml
.
1.
Navigate to
C:\Program Files\Avigilon\Avigilon AMAG Gateway\
.
NOTE: The filepath may be different depending on how your system is configured.
2.
Copy and paste the
AlarmConfig.xml
file to a back up location.
Restoring Mapped alarms
When you have a backup copy of the mapped alarms, you can restore the mapped alarms
any time.
1.
Locate your backup copy of the
AlarmConfig.xml
file.
If you are restoring a backup from a previous version of the integration, locate
your backup copy of the
GatewayParams.xml
file.
2.
Copy and paste the backup
AlarmConfig.xml
file into the
C:\Program
Files\Avigilon\Avigilon AMAG Gateway\
folder.
If prompted, allow Windows to overwrite the copy that is currently in the folder.
3.
Open the integration Configuration Tool. The restored mappings should be
displayed in the Alarm Mappings list.
4.
Click Save and Apply to update the Gateway Windows service and apply the
alarm mapping changes.