Ventamatic NXMD1WH - Manual (Page 2)

The NuVent Designer Light (Models NXMD1AB, NXMD1OB, and
NXMD1WH) is designed to be used with any pre-installed NuVent MR
or MS Series fan-light (all of which use the M2000 Universal Housing™).
(For installation as a separate light fixture see previous page.)
2. Remove the grille from the pre-installed NuVent fan-light.
Note: On units manufactured prior to 2005, the grille is mounted to
the housing with torsion springs; on units manufactured during or
after 2005, the grille/light assembly is mounted to the housing with a
hex screw.
INSTALLATION INSTRUCTIONS FOR USE WITH BATH FAN
7. Attach the mounting bracket to the motor plate with four 1/2"
pan head screws (provided).
8. Reinsert the motor plate in the housing and secure motor plate
with motor plate screw removed in Step 4.
11. Insert the quick connector on the Designer Light frame into the
same receptacle in the pre-installed housing from which the old light
assembly was disconnected in Step 3.
12. Position the keyhole slots in the Designer Light frame over the
two screws in the mounting bracket. Twist in place and secure
Designer Light frame by tightening screws in mounting bracket.
13. Insert two 60W incandescent bulbs or two compact fluorescent
bulbs into light sockets.
14. Install glass dome. Twist slightly to secure.
9. Reinsert the motor quick connector.
4. Remove the motor plate screw (Figure 2A). Store screw safely until
needed in Step 8. Remove the motor quick connector (Figure 2B).
FIGURE 2
2A
2B
FIGURE 3
5. Slide the motor plate out of the housing as indicated in Figure 3.
3. Unplug the light assembly quick connector. (See Figure 1.)
FIGURE 1
1. The NuVent Designer Light frame has a pre-installed center bolt
that will not be used in this installation. Remove.
10. Insert the two 2" Phillips pan head screws (provided) in the
mounting bracket. See Figure 5.
FIGURE 5
6. Place the motor plate on a bench or other flat surface. Center the
mounting bracket (provided) on the motor plate (See Figure 4A).
Using the four pre-drilled holes in the mounting bracket as a template
(Figure 4B), mark on the motor plate the position of the holes.
Remove the mounting bracket. Drill the four marked holes in the
motor plate using a 1/8" drill bit.
FIGURE 4
4A
4B
4B {
{