Ventamatic CX36BD2SPD User Manual
Installation instructions, For whole house fans, Caution
-1-
Models:
CX242DDWT, CX302DDWT, CX24BD2SPD, CX30BD2SPD, CX36BD2SPD
Read all warnings and instructions before beginning to install this fan.
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY OR EVEN DEATH
1. Do not attempt to use this fan with any speed control device.
2. Use this unit only in the manner intended by the manufacturer. If you have any
questions, contact the manufacturer.
3. Before servicing or cleaning this unit, switch power off at the service panel and
lock out to prevent power from being switched on accidentally. When service
disconnecting means cannot be locked, securely fasten a prominent warning
tag to the service panel.
4. Installation work and electrical wiring must be performed by a qualified person
in accordance with all applicable codes and standards, including fire-rated
construction.
5. When cutting or drilling into a wall or ceiling, do not damage electrical wiring
and other hidden utilities.
6. The combustion airflow needed for safe operation of fuel-burning equipment
may be affected by this unit’s operation. Follow the heating equipment
manufacturers guideline and safety standards such as those published by the
National Fire and Protection Association (NFPA), and the American Society for
Heating, Refrigeration and Air-conditioning Engineers (ASHRAE), and the local
code authorities.
CAUTION
1. This unit has an unguarded propeller. Do not use in locations readily
accessible to people or animals.
2. For general ventilating use only. Do not use to exhaust hazardous or
explosive materials and vapors.
3. Carbon monoxide is an odorless, colorless gas that can kill. It may
be drawn into the house by operating this fan if your fuel-burning
equipment is not properly maintained, or if you lack adequate attic
VENTAMATIC, LTD.
100 WASHINGTON STREET, MINERAL WELLS, TX 76068-0728
PHONE: (800) 433-1626 - FAX: (940) 325-9311 -
www.bvc.com
INSTALLATION INSTRUCTIONS
FOR
WHOLE HOUSE FANS
DOUBLE CHECK FAN BLADES ARE SECURE TO HUB PRIOR TO
INSTALLATION. BLADES CAN BE DAMAGED DURING SHIPMENT AND
CAN BECOME A HAZARD UPON ACTIVATION OF MOTOR!