Triton RL2000 User Manual - Manual (Page 101)

182 Currency cassette low. Valid for
SDD and GND mechanisms only. With the low currency feature enabled, this error condition will occur
before the cassette is actually empty. There should be about 1/4
inch of currency (approximately 60 bills) in the cassette when the
error is detected. To clear an Error 182:
1. Reset the cash dispenser by switching the main power switch
OFF for a few seconds and then switching it back ON.
2. Remove the cassette from the dispensing mechanism.
3. Press the reset error key.
4. Refill and install the cassette in the dispensing mechanism.
5. When the low currency function is disabled, the dispenser will
dispense every note in the cassette then go “out of service” for an
error code 33 (feed failure).
183 Receipt printer paper is low 1. Install a new roll of paper if needed.
2. If this does not correct the problem, verify that the paper low
sensor is correctly attached to the paper bracket and that the cable
between the paper low paper feed assembly and the docking
assembly is undamaged and securely connected at both ends.
3. The paper low sensor may be dirty and require cleaning.
4. Otherwise, the possible causes of the problem may be a
defective paper low sensor, cable, docking assembly or. A
temporary fix to this problem may be to set the “low receipt paper”
parameter to “in service” so that the terminal software does not
read the input from the low paper sensor. When this is done, the
terminal will operate normally until it is completely out of paper.
Then it will go “out of service”” for and error code 195 “out of
paper”.
185 Telephone number not configured Enter Management Functions and configure the telephone number.
186 Bill Size not configured This value is factory defaulted to $0.00. Allowable bill sizes are 5,
10, 20, 50, and 100. Enter the Management Functions and
configure the bill size.
187 Maximum withdrawal not
configured Enter the management functions and configure the “multiple
amount” parameter. The maximum withdrawal cannot exceed 50
time the denomination of the bill size in the cassette.
188 PIN working key not configured Enter the management functions and configure (download) the
working key.
189 Terminal ID not configured Enter the management functions and configure the “terminal ID”
number.
190 PIN Master key not configured Enter the management functions and configure the “PIN master
key”.
Note: This error code is often caused by a SPED tamper. If you
suspect SPED tamper or Error code 205, see the corrective action
for Error Code 205.
191 Feed Failure This error is usually associated with an empty note cassette or
currency that is in “unfit” condition.
1. Refill the cassette as needed.
2. Inspect the cassette and feed path for currency that is stuck
together or jammed.
3. If no jam is located, remove the first note from the cassette.
Purge the dispenser. Do several test dispense operations.
a. If the test dispenses are completed normally, and the return
code are correct, clear all errors and place the cash dispenser in
operation.
b. If the test dispenser fails again, try testing while pushing in on
the cassette. If it works then, the cassettes may not staying locked
in the cassettes. Determine what is causing the cassette to not stay
locked in place.
4. If the currency is in “fit” condition and the error persists,
consider replacing the cassette or the dispenser.
18