Triton RL1600 Installation Manual - Manual (Page 5)

5
rl1600 i
nstallation
M
anual
This document contains the information necessary for the preparation and installation of an RL1600 Triton
ATM. It’s important that the site complies with the requirements specified in this document. In addition,
electrical wiring and mechanical systems must also comply with all relevant laws and regulations.
The site must be prepared by the customer or his agent who is fully conversant with the requirements of
installing ATM equipment. The responsibility for ensuring that the site is prepared in compliance with this
document remains with the customer.
For information and guidance only, a list is provided in general terms of those matters for which the cus-
tomer is responsible. The list is not intended to be comprehensive and in no way modifies, alters, or limits
the responsibility of the customer for all aspects of adequate site preparation.
1. Location of the equipment and site preparation.
2. Site wiring (power, communication). Ensure access will not be hindered by cabinet placement.
3. Location of other equipment that may cause electrical, electromagnetic or heat induced interfer-
ence.
4. Make building alterations to meet wiring and other site requirements.
5. Install all communication cables, wall jacks, and associated hardware.
6. Provide and install necessary power distribution boxes, conduits, and grounds.
7. Ensure all applicable codes, regulations, and laws (electrical, building, safety) are adhered to.
8. Ensure the environmental requirements of this unit are met.
9. Install the unit at a height which meets the ADA/DDA/CSA accessibility regulations for the state/
country installed. Refer to Appendix B.
s
ite
C
oMplianCe
SITE PREPARATION CHECKLIST
Select site and design a floor plan
Ensure environmental conditions met
Establish contractor and vendor schedules
Check communication line requirements
Plan installation accessory needs
Check floor plan and make necessary
alterations
Install electrical requirements
Prepare site for communication needs
Plan operator training (optional)
Install communication lines and test
Ensure installation accessories are available