Triton RL1600 Installation Manual - Manual (Page 16)

16
rl1600 i
nstallation
M
anual
C
aBinet
i
nstallation
The following procedure applies to installing the cabinet assembly using either standard (P/N 06200-00066)
or chemical (06200-00060) anchor kits. The anchor kits are not supplied with the unit, but are available
from Triton. A shim kit (P/N 02322-00038) for leveling the unit is available from Triton, and is highly
recommended. An unlevel cabinet may cause the door to not close properly.
1. Carefully inspect the shipping container for any damage and report any damage immediately to the
shipping company. Refer to the warranty information in the User or Service manual (as applicable) for
information about reporting shipping damage.
2. Remove the ATM cabinet from the carton by cutting the straps and removing the top of the box.
3. Remove the packing material from inside of the box.
4. Remove the silver key from the white plastic bag attached to the ATM wrapping.
* iMportant *
Model RL1600TM is designed for INDOOR use only!
u
npaCk
atM
Tools Required
Torque wrench, adjustable to at least 60 foot pounds,
adjustable crescent wrench, or ratchet wrench
Center punch (or equivalent) for marking drill points
Hammer 3/4" (19 mm) socket Large flat screwdriver
Bubble level 7/16" socket / box wrench Safety goggles
Hearing protection
1/4" (6 mm) , 1/2" (12 mm),
and 9/16" (15 mm) carbide-
tipped masonry drill bits - at
least 6" long
3/4" heavy -duty electric
drill (rotary/hammer)
Back support belt Portable vacuum cleaner Wire brush
Standard Anchor Kit
1/2" flat washers
1/2" x 4-1/4" sleeve-type
anchor bolts
1/2" nuts
Chemical Anchor Kit
Hex nuts and
washers
Chemical anchor capsules
Threaded chisel-point
rods