Triton RL1600 Installation Manual - Manual (Page 17)

17
rl1600 i
nstallation
M
anual
5. Remove the remainder of the box from the ATM if necessary.
6. Remove the wrapping from the ATM.
7. Use the silver key to unlock both the control panel and the fascia
door (which conceals the locking mechanism) on the front of
the cabinet. Open the fascia door.
8. Lift the handle under the bill chute to open the front enclosure
door. If the door is locked, see the sidebar on this page for help
in unlocking the electronic or mechanical lock, if applicable..
9. Remove the packing material from inside the vault enclosure.
Next, carefully remove the dispensing mechanism shipping
container for the Mini Mech if required. Inspect the container
and dispenser and report any damage to Triton. Set the
mechanism aside. This may be installed in later steps.
10. The accessory box is shipped inside the cabinet enclosure.
Open and inspect the contents. Check the contents against the
enclosed packing list and report any missing parts to Triton.
UNLOCKING
COMBINATION LOCKS
Mechanical Lock. There are two
marks on the dial ring. The index
mark at the top of the dial is used
for opening the lock. A revolution
is counted each time the selected
number is aligned with the open-
ing index.
Locks are shipped on a factory
setting of ‘50’. To unlock, turn
the dial to the left (counterclock-
wise) FOUR (4) turns, stopping
on ‘50’. Then turn the dial to the
right (clockwise) until the bolt is
retracted.
Electronic Lock. The combina-
tion of the lock is preset to 1-2-3-
4-5-6. To unlock, enter the preset
combination and check for proper
operation. After each keypress,
the lock will ‘beep’. After the final
digit has been entered, the lock will
beep twice, and the open period
begins. When a valid combination
has been entered, the operator will
have approximately 3 seconds to
open the lock. To open the lock,
turn the outer ring of the dial clock-
wise. After the lock is opened, the
vault door may be opened.
**WARNING**
DO NOT APPLY POWER TO THIS
TERMINAL UNTIL THE INSTALLA-
TION IS COMPLETE!!