Triton RL1600 Installation Manual - Manual (Page 24)

24
rl1600 i
nstallation
M
anual
This unit may be equipped with more than one power cord. Disconnect All Power Cords prior to Servic-
ing! For continued fault protection, follow the correct voltage and current ratings when replacing any fuses.
Route AC Power and
Communication Cable
1. Route the AC power cord and the phone (or Cat-5) cable through either the main or alternate cable
access hole (as applicable).
2. Connect the AC power cord and communication cable to their respective facility outlets.
NOTE: Before you start, unlock and open the control panel. Verify that the power switch on the unit’s
power supply is in the oFF (0) position. Close the control panel.
3. Secure/plug the unused access hole with the grommet or plug provided.
Main cable
access hole