Tele Vue ACF-2125 Low-Profile Adapter - Manual

ACF-2125 LOW-PROFILE ADAPTER
This adapter allows 1¼" eyepieces, Barlows and accessories to be used
in 2" focusers, housings, extension tubes, diagonals, etc. The brass
clamp ring assures tight, non-marring locking. Use of Tele Vue 1¼"
eyepieces (with their matching undercuts on the barrels) will minimize the
possibility of accidental eyepiece fall-out.
IMPORTANT WARNING
IF YOU ARE USING THIS ADAPTER IN A 2" DIAGONAL, BE SURE THAT THE 1¼" COMPONENTS
(SUCH AS BARLOWS) DO NOT CONTACT THE DIAGONAL MIRROR. IF THERE IS A DANGER OF
CONTACT, CONSIDER USING TELE VUE’S "HIGH HAT" ADAPTER INSTEAD (ACR-2125).
Rev: 11/26/2008
ACF-2125 LOW-PROFILE ADAPTER
This adapter allows 1¼" eyepieces, Barlows and accessories to be used
in 2" focusers, housings, extension tubes, diagonals, etc. The brass
clamp ring assures tight, non-marring locking. Use of Tele Vue 1¼"
eyepieces (with their matching undercuts on the barrels) will minimize the
possibility of accidental eyepiece fall-out.
IMPORTANT WARNING
IF YOU ARE USING THIS ADAPTER IN A 2" DIAGONAL, BE SURE THAT THE 1¼" COMPONENTS
(SUCH AS BARLOWS) DO NOT CONTACT THE DIAGONAL MIRROR. IF THERE IS A DANGER OF
CONTACT, CONSIDER USING TELE VUE’S "HIGH HAT" ADAPTER INSTEAD (ACR-2125).
Rev: 11/26/2008
ACF-2125 LOW-PROFILE ADAPTER
This adapter allows 1¼" eyepieces, Barlows and accessories to be used
in 2" focusers, housings, extension tubes, diagonals, etc. The brass
clamp ring assures tight, non-marring locking. Use of Tele Vue 1¼"
eyepieces (with their matching undercuts on the barrels) will minimize the
possibility of accidental eyepiece fall-out.
IMPORTANT WARNING
IF YOU ARE USING THIS ADAPTER IN A 2" DIAGONAL, BE SURE THAT THE 1¼" COMPONENTS
(SUCH AS BARLOWS) DO NOT CONTACT THE DIAGONAL MIRROR. IF THERE IS A DANGER OF
CONTACT, CONSIDER USING TELE VUE’S "HIGH HAT" ADAPTER INSTEAD (ACR-2125).
Rev: 11/26/2008
ACF-2125 LOW-PROFILE ADAPTER
This adapter allows 1¼" eyepieces, Barlows and accessories to be used
in 2" focusers, housings, extension tubes, diagonals, etc. The brass
clamp ring assures tight, non-marring locking. Use of Tele Vue 1¼"
eyepieces (with their matching undercuts on the barrels) will minimize the
possibility of accidental eyepiece fall-out.
IMPORTANT WARNING
IF YOU ARE USING THIS ADAPTER IN A 2" DIAGONAL, BE SURE THAT THE 1¼" COMPONENTS
(SUCH AS BARLOWS) DO NOT CONTACT THE DIAGONAL MIRROR. IF THERE IS A DANGER OF
CONTACT, CONSIDER USING TELE VUE’S "HIGH HAT" ADAPTER INSTEAD (ACR-2125).
Rev: 11/26/2008