Easy installation instructions, Step i - prepare the softener – Star Water Systems S15DC39DR User Manual

Page 4

STAR WATER SYSTEMS

| 95 North Oak St. | Kendallville, IN 46755 | starwatersystems.com

EASY INSTAllATION INSTRuCTIONS

Step i - prepare tHe SoFtener

1. Install the unit in the water line ahead of the water heat-

er, close to a drain and a 115 volt grounded outlet , on a
flat surface. NOTE: Make sure electric outlet is grounded
and cannot be turned off by a wall switch or pullchain.
Install unit in an area protected from the elements and
freezing.

2. Remove the salt compartment cover.

3. Remove two thumb screws

4. Slide upper hood assembly to front of unit. NOTE: There

are wires connecting display hood to control valve. Do
not move assembly further than shown as wires will
become tight and pull away from display panel.

5. Check inlet and outlet for correct water flow, matching

arrows on valve head and on bypass valve (especially if
replacing an existing unit). CAUTION: Install in direction
of arrows.

This manual is related to the following products:

S15DC29DR