Spectra Precision Layout Pro Field Software Quick Start Guide - Manual (Page 30)

20
• Tap Next.
• Select the point from the plan where to set up the
instrument ([1]). Set up the instrument at this
location.
• Tell Layout Pro whether you want to measure elevation
( Yes/No) then tap Next. If you are setting up on a known
point and you want to measure elevation, first enter the
instrument height, then tap
Next.
• Select the reference point from the plan ([2]). Have a
target placed over this point.
• Check that everything is ready for a shot ([3]), aim the
instrument at the target and then tap Shoot.
• After Layout Pro has reported a valid measurement
([4]), tap Finish. Station setup is now complete.
NOTE: If there is only one point stored in the plan,
then Layout Pro will assume this point (with known
coordinates) is occupied by the instrument, and will
prompt you, from this point, to shoot a reference point
with unknown coordinates.
[1] [2]
[3] [4]