Spectra Precision Layout Pro Field Software Quick Start Guide - Manual (Page 18)

8
• Tap on the Finish button if you agree (below right),
otherwise tap to redo the placement or select
another point pattern.
The points from the point pattern are named as follows:
-
Example: “2-2” designates the 2nd point in the point pattern anchored to
point 2 in the plan.
NOTE: The same point pattern may be anchored to
different points in the plan, with different rotation values.
Deleting a Point
Pattern
Points belonging to a point pattern may be deleted
individually using the same procedure as the one used to
delete any other “normal” point.
You can also delete a point pattern in one operation, i.e. you
can delete all its points at once.
• Go to Plan and select Input Plan.
• Tap Edit, then Delete > Del. Pts Pattern.
• Tap on to be able to select a point pattern on the map
with the stylus.
• Tap on any point part of the pattern, including the anchor
point (a point part of the pattern will appear in red, the
anchor point in blue).
• Tap ok at the bottom of the screen. Layout Pro will
highlight all the points concerned, including the anchor
point (which however will NOT be deleted as a point).
• Tap on the Delete button if you agree.