Spectra Precision Layout Pro Field Software Quick Start Guide - Manual (Page 27)

17
5. Select Built-in Radio and then enter the radio channel
( Radio Channel) and network ID (Network ID) required to
communicate with the FOCUS 30.
The radio channel and network ID you should type in are
those you can read on the FOCUS 30 Face 2 control unit
(e.g. Radio Channel=5 and Network ID=9).
6. Tap to enter these two parameters. Wait until the data
collector detects the FOCUS 30 and establishes the radio
connection. The data collector screen then looks like
screen [3] below.
From now on, as long as the robotic total station remains
connected, the status bar will provide access to the
following information taken from the robotic total station:
– 4: Access to Instrument Control Panel consisting of
nine different buttons (Reflectorless ON/OFF, EDM
Standard/Tracking, Level Bubble, Turn-To, Tracklight
ON/OFF, Laser ON/OFF, Joystick, LockNGo ON/OFF,
Search), HA setting and a
Measure function (see screen
[4] above).
– 5: Target type selection and search angle range
settings. A new target search will be automatically
started when quitting this screen by tapping
OK.
– 6: Remaining power in the FOCUS 30 battery.
[1] [2]
[3] [4]
4 5 6