Spectra Precision ProMark 120/220 Handheld Platform - Manual (Page 37)

English
31
(1) Internal modem used in CSD mode.
(2) Using a network connection requires prior steps,
illustrated in the two diagrams below, for the receiver to
connect to a GPRS or CDMA network. See also Using the
Internal Modem on page 19 (for a GPRS connection), CDMA
Connection Using an External Cell Phone on page 21.
The Base receiver type option makes sense when the receiver
is used as a rover. It may be used to optimize the reception of
the corrections received from the base, which is done by
specifying the brand of the receiver used at the base. This
setting will be ignored if your receiver is used as a base. The
default setting for this option is “Automatic”.
When a network connection becomes active (and this option
is highlighted in the list of possible data links), the
Connect..
button is changed into a Disconnect button.
Note: An active modem connection can only be ended manually.
Remember that the connection will NOT be closed automatically
when quitting GNSS Toolbox.
ISP data required: APN, user, password,..
Connect to network ..
Modem connection used: “Cellular line (GPRS)”
Activate Phone function
Insert SIM card
Set Direct IP or NTRIP
parameters
Set Direct IP or NTRIP
parameters
GPRS CDMA
ISP data required: user, password..
Let cell phone connect to network..
Run DialUpString utility to prepare external
cell phone for a network connection
Modem connection used: via “Bluetooth”
Ask for Bluetooth pairing between
receiver and cell phone