Operating the spreader, Model # sp-9800x – SnowEx SP-9800X User Manual

Page 8

Operating the Spreader

Model # SP-9800X

For a heavier pass:

Decrease vehicle speed

Increase Auger speed

For a lighter pass:

Increase vehicle speed

Decrease Auger speed

For a wider pass:

Increase spinner speed

Spread ice melters with the storm to prevent unmanageable levels of ice.

Never exceed 10 miles per hour when spreading.

Calculate spread pattern when near vegetation and other vehicles.

Never operate spreader near pedestrians.

WARNING: Do not overload vehicle.

Use chart below to calculate weight of material. Weights of material are an average for dry materials.

WARNING: Never leave material in hopper for long periods of time as salt is hygroscopic and will attract atmospheric moisture and harden up.

When spreading sand mix, a 1:1 ratio for Sand/Salt mix is recommended to prevent the material from freezing.

Spreading Tips

Spreader Loading

Material

Weight Per Cubic Ft.

Rock Salt

80-90 lbs.

Sand/Salt Mix

95-120 lbs.

1. Push On/Off button.
2. Press the Start/Stop button. Auger and Spinner will begin to turn, spreading material.
3. Use dials in center of Control Pendant to adjust Material Distribution Shaft speed. This will change the spread rate at constant vehicle speed.
4. Press Start/Stop to stop spreading.
5. Turn off Spreader by pushing the On/Off button.

Spreader Operation