Installation instructions, Model # pws-100 – SnowEx PWS-225 User Manual

Page 6

AS — 6

Installation Instructions

Model # PWS-100

REFER TO PAGE AS-7 FOR DIAGRAM.

Step 1: Mount pump to tank using flangebolts . Pump output needs to be on the same side as lower

tank outlet ports.

Step 2: Assemble filter assembly and attach to pump inlet side, then attach suction hose with hose clamp to filter

assembly.

Step 3: Install 90 degree barb fitting to lower tank port (See illustration). Attach suction hose with hose clamp to

barb fitting.

Step 4: Install nozzle supply hose to pump output side using hose clamp, . At this point you can install carry handle to tank

using flange bolts .

Step 5: Assemble female disconnect and 1/2” hose barb to 3/8” pvc main supply hose with hose clamp

(See illustration).

Step 6: Assemble items #7, #15, #8 and #12 using hose clamps. (See illustration)

Step 7: Install nozzle bracket to spreader. See pg PW-5 for proper location based on spreader type.

See pg PW-5 for proper location based on spreader type.

Step 8: Mount spray nozzle to nozzle bracket using retainer nut .

Step 9: Connect male disconnect to female disconnect ; complete connection between the pump and the nozzle.

Step 10: Continue to page PW-8 for the electrical power supply portion of the installation.

This manual is related to the following products: