Hydrostatic tube assembly instructions – SnowEx PWS-225 User Manual

Page 21

AS — 21

Hydrostatic Tube Assembly Instructions

Model # PWS-175/225

REFER TO PAGE AS-20 FOR DIAGRAM

NOTE: All male threads are pre-Teflon taped.
NOTE: V-Maxx Spreader should be in truck during installation.

Step 1: Assemble hydrostatic tube to standpipe

by threading together. Make sure teflon tape is secure and in proper

Step 2: Install straight barb on the tee end of tube assembly facing tank/pump.

Step 3: Connect , , and to hose 13 from Section A (previous instructions) using hose clamp .

Step 4:

Mount the hydrostatic tube assembly to the V-Maxx vertical support (see page AS-4 top photo). Use

conduit clamp and self drilling screw to secure assembly to frame in three places.

Step 5: Install hose barb into hydrostatic tube opposite of the tee end.

Step 6: Install pump cover from section A (previous instructions) using self drilling screw . The cover is

Cut to length hose from section A (previous instructions) between pump manifold and hydrostatic

position.

equalizer tube assembly; connect using hose clamps .

notched to allow hose to pass through both sides.

This manual is related to the following products: