Tank & bracket installation instructions, Model # pws-225 – SnowEx PWS-225 User Manual

Page 17

AS — 17

Tank & Bracket Installation Instructions

Model # PWS-225

NOTE: All male threads are pre-Teflon taped.

NOTE: V-Maxx Spreader should not be in truck during installation.

Step 1: Position left and right main brackets over tank.

Step 2: Start screws through cross brace into main brackets.

Step 3: Rest against side frame of spreader in desired position and mark holes in bottom rail.

Step 4: Drill holes in bottom rail for 1/2” bolts.

Step 5: Hook adjustment brackets to top rail, you may have to pry over plastic hopper to fit properly.

REFER TO PAGE AS-11, AS-33 TO ASSIST WITH THE INSTALLATION.

REFER TO PAGE AS-16 TO COMPLETE STEPS 1-11.

Step 6: Set assembly against side frame and fasten together. Tighten all bolts at this time.

Step 7: Install fitting D6967 into saddle tank (see pg 18).

Step 8: Measure and cut hose to fit between saddle tank and front tank (see pg 18).

Step 9: Install hose using clamps D6963.

Step 10: Fill tanks enough to check for any leaks.

This manual is related to the following products: