Pump/tank/control installation instructions – SnowEx PWS-225 User Manual

Page 16

AS — 16

Pump/Tank/Control Installation Instructions

Model # PWS-175/PWS-225

REFER TO PAGE AS-13,14,15 FOR DETAILED INFORMATION.

NOTE: All male threads are pre-Teflon taped.
NOTE: V-Maxx Spreader should not be in truck during installation.

Step 1: Mount control in desired location in cab using supplied hardware.

Step 2: Route battery leads to battery but DO NOT connect at this time.

Step 3: Route vehicle harness to pump location by motor/trans mount. DO NOT connect to pump at this time.

Step 4: Remove upper front rail on V-Maxx Spreader, install front tank over lower rail. This will help keep tank locked in position.

Re-install upper rail.

Step 5: Install 3/4” NPT plugs in open ports except for the port closest to the passenger. Install 90° barb fitting.

Step 6: Cut to length and install hose to using hose clamp , route hose over lower rail.

Step 7: Cut to length and attach strainer assembly ( , , , ) to hose using clamp . Make sure to keep strainer level.

Step 8: Attach hose with clamp ; this hose will be routed from strainer assembly to the pump manifold closest

to the tank.

Step 9: Once you have made sure all parts from the tank to the pump are routed correctly and all clamps are tight, you can

then mount the pump.

Step 10: Position pump between the V-Maxx motor/trans cover and the passenger side lower rail. (See page AS-4 upper photo)

Center pump front-to-back and mount pump using self drilling screw with washer .

Step 11: Attach hose using clamp to pump manifold .

This manual is related to the following products: