beautypg.com

Events logging, Events playback, Start failure codes through the parking lights – Autostart MANUAL TRANSMISSION REMOTE STARTER AS-1785 User Manual

Page 23

background image

AS-1785 Installation Guide

P. 23

2. Press and release the Break Pedal 6 times (within 10 seconds from entering

Programming Mode).

3. The Parking Lights will flash 8 times to confirm resetting.

Table 10: Resetting without a Valet Button

On some vehicles (such as BMW and certain Volkswagen vehicles), resetting will not work if the
Brake Pedal is pressed while the Ignition Key is not in the

IGNITION ON (RUN)

position: you will need

therefore to hot-wire the Brake Pedal by manually jumping 12 V with a fused test lead at the Brake
Pedal switch.

1. Flash the Hood Pin switch (see Table 1)

– Once inside Programming Mode, you have 10 seconds to complete the next step.

2. Press and release the Valet Button 6 times or more until the Parking Lights start to

flash.

3. The Parking Lights will flash 8 times to confirm resetting.

Table 11: Resetting with the Valet Button

Events Logging

With this feature, the Remote Car Starter will play back the last 4 Start Failure Events Codes and
the last Intrusion Code via the Parking Lights or L.E.D.

Events playback

Ensure that the Hood is up, that the vehicle is not in Valet Mode and that the Ignition is

OFF

.

• Hold down the Hood Pin-switch for 4 seconds.

• Release the Pin-switch. The Parking Lights will come on.

• While the Parking Lights are on, immediately push the Pin-switch 3 more times

(down-up / down-up / down-up).

The Parking Lights and L.E.D. will flash the five events stored in memory.

Table 12: Events playback

The first four playback codes are Start Failure Events. There is a pause after each event code is
played back. The system will play back the most recent event first, then the second one, and so on.
If there is no event at all to report, the Parking Lights will give one long flash.

Start Failure Codes through the Parking Lights

1 x = No Start
3 x = Hardware Reset
4 x = Brakes
5 x = No Tach Cut-off
6 x = Hood
7 x = Engine Running, no Ignition detected, or Tach before Start
Note: “x” stands for one flash of the Parking Lights