Autostart MANUAL TRANSMISSION REMOTE STARTER AS-1785 - Manual (Page 13)

AS-1785 Installation Guide P. 13
memory, you must perform a reset of the Remote Car Starter (see Resetting the Remote Car
Starter, later in this Guide, for more details).
The Transmitter Programming Procedure
1. Flash the Hood Pin switch (see Table 1)
– The Parking Lights will stay ON for up to 20 seconds.
– Before the lights go out, turn the Ignition Key to the IGNITION ON (RUN) position.
– Immediately turn the Ignition Key back to the OFF position.
2. Press and hold the LOCK button and keep it down until the Parking Lights flash
5 times quickly.
– The Remote Car Starter has stored the code of the Transmitter into memory.
3. To exit: close the Hood.
Table 2: Programming a Transmitter
To program a Transmitter on the second vehicle for Multi-car Operation, you must press the
TRUNK and LOCK buttons simultaneously (instead of LOCK or UNLOCK ) in step 3 of the Transmitter
code-learning procedure:
Entering Programming Options Mode
The Remote Car Starter is equipped with three custom programming Modes that allow the installer
to custom-fit the system outputs according to installation requirements. The Programming Options
are designed to facilitate interfacing with all vehicle types. (See section Table of Programming
Options later in this Guide.)
1. Flash the Hood Pin switch (see Table 1)
– The Parking Lights will stay ON for up to 20 seconds.
– Before the lights go out:
2. Press and hold the Brake Pedal,
– And press one of the following buttons on the Transmitter:
•
LOCK ..................to access Mode 1;
•
UNLOCK ..............to access Mode 2;
•
TRUNK ................to access Mode 3.
The Parking Lights will flash and the Horn will honk once, twice or three times to
confirm entry into a Mode.
3. Release the Brake Pedal.
Table 3: Accessing modes
Note
The Unit will stay in the selected programming Mode until the Hood Pin-switch or the Brake Pedal
is pressed again. Therefore take your time to make the proper selection. Pressing the Brake
Pedal will take you back to the Programming Centre, where you can select a different Mode.
Once you access a particular programming Mode, you will automatically start at Function 1. Once
you select one of the Options of Function 1, you will automatically be taken to the next Function.
To select one of the four Options of any given Function, press the corresponding button on the
Transmitter:
•
LOCK button .........................to access Option 1
•
UNLOCK button .....................to access Option 2
•
TRUNK button .......................to access Option 3
•
START button .......................to access Option 4