Autostart MANUAL TRANSMISSION REMOTE STARTER AS-1785 - Manual (Page 17)

AS-1785 Installation Guide P. 17
a. To increase the Horn pulse by 3 ms, press the LOCK button.
b. To decrease the pulse by 3 ms, press the UNLOCK button.
c. To increase the pulse by 10 ms, press the START or STOP button.
d. To decrease the pulse by 10 ms, press the TRUNK button.
5. To save the new settings: press LOCK and UNLOCK . If 3 honks are returned the new
settings have been saved.
Table 9: Adjusting Honk Duration
Otherwise close the Hood to cancel the changes.
For each timing change, the Horn will honk with the new settings, except in the
following cases:
• When the lower limit of 5 ms is reached, there will be a 1/4-sec. honk.
• When the upper limit of 200 ms is reached, there will be a 3/4-sec. honk.
A system reset will set the Remote Car Starter back to the default values: 30 ms.
Testing
Before putting back the vehicle together, it is recommended to check that the system operates
properly. The following testing procedures should be used to verify proper installation and
operation of the system. Before testing, make sure that all connections are soldered and that the
unit is plugged in.
‰ Make sure the Remote Car Starter properly enters and exits Ready Mode:
Setting the system to Ready Mode
1. Ensure that all the Doors are closed and that the Gear Shift Lever is in the
NEUTRAL
position.
2. With the Engine already running, apply the Parking Brake and release the Brake
Pedal.
Make sure to release the Brake Pedal.
3. Within 20 sec. push
LOCK
,
UNLOCK
or
START
on the Transmitter.
The Parking Lights will flash 3 times quickly and remain lit.
4. Remove the key: the Engine will go on running.
5. Exit the vehicle and close the Door.
6. Press and hold either:
a.
LOCK
to lock the Doors and shut down the Engine or enter Turbo Mode ;
b.
UNLOCK
to unlock the Doors and shut down the Engine or enter Turbo Mode ;
c.
STOP
to shut down the Engine without affecting the Doors.
Table 7: entering Ready Mode