Autostart MANUAL TRANSMISSION REMOTE STARTER AS-1785 - Manual (Page 15)

AS-1785 Installation Guide P. 15
FUNCTION 3 – Turbo Mode
OPTION 1 Turbo Mode ENABLED
OPTION 2* Turbo Mode DISABLED
OPTION 3 Turbo Mode ENABLED
FUNCTION 4 – Engine type and Cold Weather Mode
OPTION 1 Diesel Mode with 20-minute Run Time in Cold Weather Mode
OPTION 2* Gas Mode with 4-minute Run Time in Cold Weather Mode
OPTION 3 Diesel Mode with 9-minute Run Time in Cold Weather Mode
FUNCTION 5 – Ignition Valet
OPTION 1 Ignition Valet DISABLED
OPTION 2* Ignition Valet ENABLED
OPTION 3 Ignition Valet ENABLED
MODE 3
* INDICATES DEFAULT SETTING
FUNCTION 1 – Home Valet TM
OPTION 1 Home Valet ENABLED
OPTION 2* Home Valet DISABLED
OPTION 3 Home Valet DISABLED
FUNCTION 2 – AUX 3 / Zone 3 Programming
OPTION 1 1-sec. output when TRUNK button is pressed for 3 sec. with Ignition OFF
or under remote run
OPTION 2* Constant output while the TRUNK button is pressed
OPTION 3 Output with Disarm and Rearm pulses
FUNCTION 3 – AUX 2 Programming
OPTION 1 Constant output while the LOCK and UNLOCK buttons are pressed.
In Safe Start Mode: activate AUX 2 by pressing the START button.
OPTION 2* Toggle ON/OFF (with 30-second timeout)
OPTION 2 Horn confirmation when lock.
OPTION 4 Priority Door Access
FUNCTION 5 – External Trigger
OPTION 1 Zone 3 disarm/rearm (Trunk Pin: a disarm pulse is sent before the Trunk
opens, the vehicle rearms 4 seconds after the Trunk is closed).
OPTION 2* Engine Start/Stop
OPTION 3 Key Sense
Tach Programming
About Tach Programming
If you press the START button before carrying out a Tach Programming procedure, the Remote Car
Starter will make no attempt to start the Engine and the Parking Lights will give 5 flashes.
If order to carry out Tach Programming, you may simply follow the Automatic Tach Programming
procedure.
The Remote Car Starter stores Tach settings regardless of the procedure used at the time of Tach
programming. All Tach settings are cleared when the Remote Car Starter is reset. A new Tach
Programming procedure has to be carried out only if the Remote Car Starter is reset.
Multi-speed Tach Programming
Tach signals may vary from vehicle to vehicle. The Remote Car Starter is designed to read a wide
range of Tach signals produced by recent Ignition systems. There is no necessary manual